Apply on Employer Site

SpaceX · 9 hours ago

Structures Technician (Composites)

Hawthorne, CA

Full-time

Onsite

Entry Level

$31/hr - $38/hr

1+ years exp

SpaceX was founded under the belief that a future where humanity is out exploring the stars is fundamentally more exciting than one where we are not. The Structures Technician (Composites) will be responsible for trimming and finishing composite and metallic assemblies, assembling structures, and repairing composite defects.

Advanced MaterialsAerospaceManufacturingNational SecuritySpace Travel

Growth Opportunities

No H1B

U.S. Citizen Only

Responsibilities

Trim and finish composite and metallic assemblies

Assemble structures including setup, bonding and fastener applications

Surface prep, using grit blast, hand abrade and power abrasion techniques

Repair composite defects

Use tooling holes, pilot holes, or by hand (as required), per drawing or tooling instructions

Align parts and secure in place using clecos or tooling/hand clamps

Check for good edge margins and alignment

Select drill bits, reamers and/or countersinking tools for pilot and full size holes

Drill, ream, countersink full size holes in parts/assemblies, in proper sequence and to correct size using drill motor

Set countersinking tools to proper depth as required

Disassemble parts and deburr holes using chip chasers, deburring tools, and files to prepare for installation of fasteners

Load and unload ovens to bond detail parts to assemblies

Handle and dispose of hazardous materials in approved manner

Determine and obtain correct type and size fasteners

Cold work holes to prepare for close tolerance fastener installation

Install bushings into housings using arbor press and/or hydraulic puller

Apply liquid nitrogen to facilitate installation of bushings

Install fasteners in correct sequence per drawing, using correct tools (e.g., rivet gun and bucking bar, drill motor, power screwdriver, C-squeeze, ratchet wrench, nut runner)

Qualification

Composite assemblyEngineering drawing interpretationUse of hand toolsReamingCountersinkingFollow instructionsAttention to detail

Required

High school diploma or equivalency certificate

1+ years of experience using hands tools in the aerospace, manufacturing, marine or automotive industry OR certificate from a credited trade school

Standing for long periods of time, climbing up and down ladders, bending, grasping, sitting, pulling, pushing, stooping, and stretching are generally required to perform the functions of this position

Able to lift and carry up to 25lbs. unassisted

Able to climb ladders and work in tight spaces

Willing to work all required shift hours, overtime and weekends as needed

Preferred

Experience with reaming, honing and/or countersinking of uniform close tolerance holes in proper sequence while using the correct tool for the job (e.g., rivet gun and bucking bar, drill motor, power screwdriver, 'C' squeeze, ratchet wrench, nut runner)

Experience reading and interpreting engineering drawings, an understanding for drawing symbols, flag notes and general notes

Experience working with composites

Ability to follow written and verbal instructions, read SOPs (standard operating procedures)

Attention to detail and accuracy while working within a fast-paced production environment